electric resistance
美 
英
英汉解释
例句
Graphite Electrode is mainly used for steel-making in electric furnace, mineral hot furnace and electric resistance furnace.
石墨电极石墨电极主要用于电炉炼钢及矿热电炉和电阻炉。
Electric resistance welding. Transformers for resistance welding machines. General specifications applicable to all transformers.
电阻焊接.电阻焊机用变压器.适用于所有变压器的通用规范
The electric resistance of a wire is the ratio of the potential difference between its two ends to the current in the wire.
导线的电阻等于该导线两端之间的电位差与导线中电流的比值。
In general, different methods are applied to define the low electric resistance oil layer due to geological features in various regions.
对低阻油层的判断可能由于各地区地质特征的不同而采用的方法有所不同；
Has burnish optimal and adhesion of good, bright colors, white electric resistance oil, alcohol etc. Characteristics.
具有光泽优、附着力佳、色彩鲜艳、耐白电油、酒精等特点。
Electric resistance welding. Pneumatic cylinders without liners for multiple spot welding machines. General specifications.
电阻焊接多点焊接机用无外壳千斤顶.一般规范
TEXTILES. TESTING OF FABRICS. DETERMINATION OF THE TRANSVERSAL SUPERFICIAL ELECTRIC RESISTANCE.
纺织.织物试验.横向表面电阻的测定
ELECTRIC RESISTANCE WELDING. RECTIFIER EQUIPMENT FOR RESISTANCE WELDING MACHINES. SPECIFICATIONS AND TESTS.
电阻焊接.电阻焊机用多组整流器.规范和试验
ELECTRIC RESISTANCE WELDING. MACHINES FOR ELECTRIC RESISTANCE WELDING WITH RECTIFIED CURRENT. SPECIFICATIONS AND TESTS.
电阻焊接.整流电流的电阻焊机.规范和试验
The skill source is each kind of electric resistance, electric capacity, IC, be partial to the wholesale that the unpopular IC wait.
一手货源各类电阻，电容，IC，偏冷门IC等的批发销售。我们有非常熟练的工人。
Under alternative loading, the electric resistance of CFRC increases as loading cycle prolongs, until the specimen is damaged.
在交变载荷作用下，碳纤维混凝土试件的电阻随著载荷周期次数的增加而增大，直至破坏；
Electric resistance welding. Machines for electric resistance welding. Specifications and tests.
电阻焊接.电阻焊机.规范和试验
Electric resistance welding. Pneumatic cylinders without liners for multiple spot welding machines. Sizes.
电阻焊接.多点焊接机用无外壳千斤顶.尺寸
ELECTRIC RESISTANCE WELDING. SPOT WELDING ELECTRODE ADAPTOR WITH PUNCHING COOLING BORE. SIZES AND TOLERANCES.
电阻。带冷却孔的点电极转接套。尺寸和公差。
Electric resistance welding - Integrated transformers for welding guns.
摘要：电阻焊接。焊接枪用电源积分变压器。
The features of electric resistance welded(ERW) carbon steel pipe are analyzed from the viewpoint of design code and material selection.
从设计规范与管材选用方面对电阻焊碳钢直缝钢管（ERW）的特点进行了分析。
ELECTRIC RESISTANCE WELDING. LOW IMPEDANCE CABLES. SIZES, SPECIFICATIONS AND TESTS.
电阻接焊.低阻抗的电缆.尺寸.规范.试验
is applied to investigate the grooving corrosion sensitivity of J55 steel oil well casing in electric resistance welding(ERW) zone.
应用控电位的电化学极化试验，测定了J55钢高频直缝电阻焊（ERW）油井套管焊接区的沟槽腐蚀敏感性。
ELECTRIC RESISTANCE WELDING. CYLINDRICAL FEMALE CAPS WITH GROOVES. SIZES AND TOLERANCES.
电阻焊.圆柱形带槽套头.尺寸和公差
Electric resistance welding. Materials for resistance welding electrodes and ancillary equipments.
电阻焊接.电阻焊接用电极材料及辅助设备
The test results show that the electric resistance of Al nano-beams with tensile stress is instability.
电学测试结果表明：张应力下金属纳米梁的电阻值不稳定。
The variation rule of electric resistance depends on the electric pole mode.
试件电极形式不同，电阻变化规律也不同。
The mass, tensile strength and electric resistance are calculated from nominal diameter.
线密度、抗张强度、电阻根据标准直径来计算。
The measurement error of the electric resistance probe is finally analyzed.
同时，对电阻探针的测量误差进行了分析论证。
Which have the following advantages: high coercive force, high electric resistance , long-time stability, and economical price.
它们具有：高矫顽力、阻抗、效稳定性和经济的价格。
Cutting planes should be clean, free from burrs or sharp edges(Electric resistance between lugs: under 0. 5 Ohm).
切割面必须整齐，无毛刺或锐边（凸缘之间的电阻要求：低于0.5欧姆）。
The electric resistance is measured in ohms.
电的反抗是用欧姆测量的。
ERWS Electric Resistance Welded steel.
电阻焊接钢。
The results show that the bulk average density by electric resistance sintering is higher than that by median frequency sintering.
研究结果表明，电阻烧结坯整体平均密度要高于中频烧结坯密度。
Measuring and three-dimensional finite element numerical simulation of residual stress of high frequency electric resistance welded pipe
高频焊管残余应力的测量及三维有限元数值模拟
Electric Resistance Stress Sensor and Infrared Transmission Pressure Recorder for Hydraulic Powered Supports
电阻应变传感与红外传输综采支架压力记录仪
Application of the Complete Energy-Saving Technique in Industrial Electric Resistance Furnace
成套节电技术在工业电阻炉中的应用
Standard Specification for Electric-Resistance-Welded Carbon Steel and Carbon-Manganese Steel Boiler and Superheater Tubes
电阻焊接碳素钢钢管及碳锰钢锅炉和过热器管的技术规范
Optimization of Intermediate Annealing for Fatigue Damaged Samples by Electric Resistance Variation
从电阻变化规律看疲劳损伤件中间退火最佳时机
Standard Specification for Electric-Resistance-Welded Ferritic Alloy-Steel Boiler and Superheater Tubes
锅炉和过热器用电阻焊铁素体合金钢管
Modeling of Electric Resistance Furnace in a Remote Simulation and Control Laboratory
面向远程仿真的电阻炉建模研究
Troubles and Solution Methods About Affected Welding Seam Quality of Electric Resistance Welding Can-body Combined Machine
影响电阻焊罐身组合机焊缝质量的几种故障及其排除方法
Standard Specification for Carbon and High-Strength Electric Resistance Welded Steel Structural Shapes
碳和高强度电阻焊接钢结构形状的标准规范
Specification for Electric-Resistance-Welded Carbon Steel Boiler and Superheater Tubes for High-Pressure Service
高压锅炉与过热器用电阻焊接碳素钢管规范
Analysis of the Influence of Slag Inclusion in Steel Plate on the Quality of Electric Resistance Welding Pipeline
钢板中夹杂物对高频电阻焊管质量影响浅析
